Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Speed Signal Circuit

for Preparation Click here


DESCRIPTION

Navigation function:
The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information about the navigation antenna, and then adjusts vehicle position.
ASL function:
The circuit is necessary for the ASL (Automatic Sound Levelizer) built into the navigation receiver. Speed signals are received from the combination meter and used for the ASL. The ASL function automatically adjusts the sound volume in order to maintain clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E130075E37


INSPECTION PROCEDURE

1.CHECK VEHICLE SPEED SIGNAL (DISPLAY CHECK MODE)
  1. Enter the "Display Check" mode and select "Vehicle Signal Check" (Click here).

  1. Check that the vehicle speed on the display changes according to the actual vehicle speed.

    OK:
    The display changes according to the actual vehicle speed.

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the vehicle speed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMBINATION METER)


    E179199E06
    E182332E01
  1. Disconnect the E57 navigation receiver assembly connector.

  1. Disconnect the E22 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E57-3 (SPD) - E22-39 (+S)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)