OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the 2 clips and open the oil pan drain service cover.
Remove the oil pan drain plug and gasket, and drain the engine oil into a container.
| 2. REMOVE OIL FILTER CAP ASSEMBLY |
![]() |
Using SST, loosen the oil filter cap 4 revolutions, align the cap ribs vertically, and drain the remaining engine oil in the oil filter cap.
| *1 | Cap Rib |
| *2 | Oil Filter Bracket Clip |
Remove the oil filter cap.
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| *1 | Oil Filter Element |
| *2 | O-Ring |
| 3. INSTALL OIL FILTER CAP ASSEMBLY |
![]() |
Clean the inside of the oil filter cap, its threads and O-ring groove.
Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
| *1 | O-Ring |
Set a new oil filter element in the oil filter cap.
Remove any dirt or foreign matter from the installation surface and inside of the engine.
![]() |
Reapply a small amount of engine oil to the O-ring of the oil filter cap. Align the oil filter cap with the oil filter bracket so that the cutout portion of the cap threads is in a position 90° from the groove in the bracket, and then temporarily install the cap.
![]() |
Using SST, tighten the oil filter cap.
| 4. ADD ENGINE OIL |
Clean and install the oil pan drain plug together with a new gasket.
Add new engine oil.
| Oil Grade | Oil Viscosity (SAE) |
| API grade SL or SM multigrade engine oil |
|
| API grade SL "Energy-Conserving", SM "Energy-Conserving" or ILSAC multigrade engine oil |
|
| Item | Specified Condition |
| Drain and refill without oil filter change | 3.9 liters (4.1 US qts, 3.4 Imp. qts) |
| Drain and refill with oil filter change | 4.2 liters (4.4 US qts, 3.7 Imp. qts) |
| Dry fill | 4.7 liters (5.0 US qts, 4.1 Imp. qts) |
Install the oil filler cap.
| 5. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the areas that were worked on.
| 6. INSPECT ENGINE OIL LEVEL |
Warm up the engine, and then stop the engine and wait for 5 minutes.
Check that the oil level is between the dipstick low level mark and full level mark.
If the level is low, check for leakage and add oil up to the full level mark.