Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    A158220
  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A209062
  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the sensor connector.



2. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    A158220
  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A209063
  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the sensor connector.



3. INSTALL NO. 2 CYLINDER HEAD COVER


    A209050
  1. Attach the 4 clips to install the cover.

    NOTICE:
    1. Be sure to attach the clips securely.
    2. Do not apply excessive force or do not hit the cover to attach the clips. This may cause the cover to break.