Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)


    A209062
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



3. REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)


    A209063
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.