Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A157503E03
  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A205042
  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or jammed during installation.

  1. Connect the sensor connector.



2. INSTALL REAR ENGINE UNDER COVER RH


    A196892
  1. Install the under cover with the 3 clips.