Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



2. DRAIN ENGINE COOLANT


    A195000E02
  1. Install a vinyl hose to the drain cock plug on the radiator side.



  1. Loosen the radiator drain cock plug.


    A245378E01

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



3. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A209051
  1. Disconnect the mass air flow meter connector.

  1. Detach the clamp.



    A209053
  1. Disconnect the No. 2 ventilation hose from the cylinder head cover.

  1. Squeeze the taps of the air cleaner hose clamp, and then disconnect the air cleaner hose from the throttle body.



    A209052
  1. Detach the 2 hook clamps, and then remove the air cleaner cap and hose.



5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A209057
  1. Disconnect the wire harness clamp from the air cleaner case.

  1. Remove the 3 bolts and air cleaner case.



6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A209066
  1. Disconnect the sensor connector.



    A209067E01
  1. Using SST, remove the sensor and gasket.

    SST
    09817-33190