Home › ENGINE ยท 3ZR-FAE › EMISSION CONTROL › PURGE VALVE

PURGE VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE PURGE VSV


    A209084
  1. Disconnect the purge VSV connector.

  1. Disconnect the 2 fuel vapor feed hoses from the purge VSV.

    NOTICE:
    Carefully disconnect the hoses while holding the purge VSV by hand.



    A209085
  1. Remove the screw and purge VSV.