Home › ENGINE ยท 3ZR-FAE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR FUEL RATIO SENSOR


    A209087
  1. Disconnect the sensor connector and clamp.



    A209088E01
  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010  

    NOTICE:
    Do not damage the sensor.