CYLINDER HEAD > DISASSEMBLY |
| 1. REMOVE INTAKE VALVE |
![]() |
Place the cylinder head on wooden blocks.
Using SST, compress the compression spring and remove the valve retainer locks.
Remove the retainer, compression spring and valve.
| 2. REMOVE EXHAUST VALVE |
![]() |
Place the cylinder head on wooden blocks.
Using SST, compress the compression spring and remove the valve retainer locks.
Remove the retainer, compression spring and valve.
| 3. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the oil seals.
| 4. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.
| 5. REMOVE NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm straight hexagon wrench, remove the 3 screw plugs and 3 gaskets.
| 6. REMOVE STUD BOLT |