ENGINE UNIT > INSPECTION |
| 1. INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY |
![]() |
Turn the roller by hand to check that it turns smoothly.
If the roller does not turn smoothly, replace the No. 1 valve rocker arm sub-assembly.
| 2. INSPECT VALVE LASH ADJUSTER ASSEMBLY |
Place the lash adjuster into a container full of new engine oil.
![]() |
Insert the tip of SST into the lash adjuster plunger and use the tip to press down on the check ball inside the plunger.
Squeeze SST and the valve lash adjuster together to move the plunger up and down 5 to 6 times.
Check the movement of the plunger and bleed the air.
After bleeding the air, remove SST. Then try to quickly and firmly press the plunger with your fingers.
| 3. INSPECT CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 147 N (15 kgf, 33.0 lbf) as shown in the illustration.
Using a vernier caliper, measure the length of 15 links.
| 4. INSPECT NO. 2 CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 147 N (15 kgf, 33.0 lbf) as shown in the illustration.
Using a vernier caliper, measure the length of 15 links.
| 5. INSPECT OIL PUMP DRIVE GEAR |
![]() |
Place the chain around the oil pump drive gear.
Using a vernier caliper, measure the diameter of the oil pump drive gear and chain.
| 6. INSPECT OIL PUMP DRIVE SHAFT GEAR |
![]() |
Place the chain around the oil pump drive shaft gear.
Using a vernier caliper, measure the diameter of the oil pump drive shaft gear and chain.
| 7. INSPECT CAMSHAFT TIMING GEAR ASSEMBLY |
![]() |
Place the chain around the camshaft timing gear assembly.
Using a vernier caliper, measure the diameter of the camshaft timing gear assembly and chain.
| 8. INSPECT CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY |
![]() |
Place the chain around the camshaft timing exhaust gear assembly.
Using a vernier caliper, measure the diameter of the camshaft timing exhaust gear assembly and chain.
| 9. INSPECT CRANKSHAFT TIMING GEAR |
![]() |
Place the chain around the crankshaft timing gear.
Using a vernier caliper, measure the diameter of the crankshaft timing gear and chain.
| 10. INSPECT CHAIN TENSIONER SLIPPER |
![]() |
Using a vernier caliper, measure the chain tensioner slipper wear.
| 11. INSPECT NO. 1 CHAIN VIBRATION DAMPER |
![]() |
Using a vernier caliper, measure the No. 1 chain vibration damper wear.
| 12. INSPECT CHAIN TENSIONER PLATE |
![]() |
Using a vernier caliper, measure the chain tensioner plate wear.
| 13. INSPECT NO. 1 CHAIN TENSIONER |
![]() |
Check that the plunger moves smoothly when the cam is raised with your finger.
| *1 | Raise |
| *2 | Move |
| *3 | Lock |
Release the cam, and then check that the plunger is locked in place by the cam and does not move when pushed with your finger.
If necessary, replace the No. 1 chain tensioner.
| 14. INSPECT CYLINDER HEAD BOLT |
![]() |
Using a vernier caliper, measure the length of the cylinder head bolt from the seat to the end.
Using a vernier caliper, measure the diameter of the elongated thread at the measuring area.
| 15. INSPECT EXHAUST MANIFOLD |
![]() |
Using a precision straightedge and feeler gauge, measure the warpage on the surface that contacts the cylinder head.