Home › ENGINE ยท 3ZR-FAE › EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR FUEL RATIO SENSOR


    A209087
  1. Disconnect the sensor connector and clamp.



    A209088E01
  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010  

    NOTICE:
    Do not damage the sensor.



3. REMOVE WIRE HARNESS CLAMP BRACKET


A207697
  1. Detach the clamp and disconnect the fuel hose.

  1. Remove the bolt and bracket.



4. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A207698
  1. Remove the 3 bolts and heat insulator.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A207699
  1. Remove the 2 bolts and disconnect the front exhaust pipe from the center exhaust pipe.

  1. Remove the gasket from the exhaust pipe.



    A207700
  1. Remove the 2 bolts, 2 compression springs and front exhaust pipe.



6. REMOVE MANIFOLD STAY


    A207701
  1. Remove the 3 bolts and manifold stay.



7. REMOVE EXHAUST MANIFOLD


    A207702
  1. Remove the 5 nuts and exhaust manifold.

  1. Remove the exhaust manifold gasket.



8. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A207703
  1. Remove the 3 bolts and heat insulator.