Home › ENGINE ยท 3ZR-FAE › IGNITION › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



2. REMOVE IGNITION COIL ASSEMBLY


    A205085
  1. Disconnect the 4 ignition coil connectors.



    A205086E01
  1. Remove the 4 bolts and 4 ignition coils.

    NOTICE:
    When removing the ignition coil, do not damage the plug cap with the cylinder head cover opening or the upper edge of the spark plug tube.

    Text in Illustration 
    *1
    Cylinder Head Cover
    *2
    Spark Plug Tube
    *3
    Plug Cap



3. REMOVE SPARK PLUG


    A205087
  1. Using a 14 mm spark plug wrench and 100 mm extension bar, remove the 4 spark plugs.