Home › ENGINE ยท 3ZR-FAE › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A085603E06
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    NOTICE:
    Do not let adhesive adhere to the oil hole.



    A153125
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch connector.



2. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.



3. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }