CLUTCH > SERVICE DATA |
| Pedal height from floor (for LHD) | for 1AZ-FE, 3ZR-FAE | 162.9 to 172.9 mm (6.41 to 6.81 in.) |
| for 2AZ-FE | 175.7 to 185.7 mm (6.92 to 7.31 in.) | |
| Pedal height from floor (for RHD) | for 1AZ-FE, 3ZR-FAE | 195.5 to 205.5 mm (7.70 to 8.09 in.) |
| for 2AZ-FE | 210.2 to 220.2 mm (8.28 to 8.67 in.) | |
| Pedal free play | - | 5.0 to 15.0 mm (0.197 to 0.591 in.) |
| Push rod play at pedal top | - | 1.0 to 5.0 mm (0.0394 to 0.197 in.) |
| Clutch release point from pedal full stroke end position | - | 25 mm (0.984 in.) or more |
| Clutch disc rivet depth | Minimum | 0.3 mm (0.0118 in.) |
| Clutch disc runout | Maximum | 0.8 mm (0.0314 in.) |
| Diaphragm spring wear | Maximum depth Maximum width | 0.5 mm (0.0196 in.) 6.0 mm (0.236 in.) |
| Flywheel runout | Maximum | 0.1 mm (0.00393 in.) |
| Diaphragm spring tip non-alignment | Maximum | 0.5 mm (0.0196 in.) |
| Clutch start switch resistance | ON (pushed) | Below 1 Ω |
| OFF (not pushed) | 10 kΩ or higher | |
| Clutch switch resistance | ON (pushed) | Below 1 Ω |
| OFF (not pushed) | 10 kΩ or higher |