Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT COMPRESSOR AND MAGNETIC CLUTCH


    E145186E08
  1. Disconnect the connector from the compressor and magnetic clutch.



    E124482E10
  1. Disconnect the connector from the magnetic clutch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (MG+) - 1
    Always
    Below 1 Ω
    3 (MG+) - Body ground
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the compressor and magnetic clutch.



2. INSPECT MAGNET CLUTCH ASSEMBLY


    E147609E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    3.4 to 3.8 Ω

  1. When connector terminal A1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.
    If the result is not as specified, replace the magnetic clutch.



3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (LOCK SENSOR)


    E127543E02
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1(SSR+) - 2(SSR-)
    20°C (68°F)
    65 to 125 Ω

    If the resistance is not as specified, replace the compressor and magnetic clutch.