Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1442    Invalid Data Received from Acceleration Sensor

DTC    C1443    Invalid Data Received from Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition.

DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data signal is transmitted continuously from the deceleration sensor for 10 seconds or more.
Yaw rate and deceleration sensor
C1443
An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more.
Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTC C1440 .

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate sensor assembly, perform zero point calibration (Click here).

1.CHECK DTC
  1. Turn the ignition switch off.

  1. Clear the DTC (Click here).

  1. Start and idle the engine for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTCs (C1442 and/or C1443) are output.
    A
    DTCs (C1442 and C1443) are not output.
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)