STOP LIGHT CONTROL RELAY > INSPECTION |
| 1. INSPECT STOP LIGHT CONTROL RELAY ASSEMBLY |
![]() |
Disconnect the A43 stop light control relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-2 (STP) - Body ground | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V | |
| A43-6 (+B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-4 (GND) - Body ground | Always | Below 1 Ω |
Reconnect the A43 stop light control relay connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-8 (OUT) - Body ground | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V |