Home › BODY › EXTERIOR › FRONT BUMPER (w/ Hood Moulding)

FRONT BUMPER (w/ Hood Moulding) > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


B254515
  1. Remove the 9 clips and radiator support opening cover.



2. REMOVE RADIATOR GRILLE PROTECTOR


B254516
  1. Remove the 3 radiator grille protectors.



3. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH (w/ Diffuser)


B252770
  1. Remove the bolt, nut, screw and front fender front splash shield.



4. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (w/ Diffuser)

HINT:
Use the same procedure described for the LH side.



5. REMOVE FRONT BUMPER COVER


    B252771E01
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.



    B254517
  1. w/ Diffuser:
    Remove the 8 screws and 4 clips.



    B255284
  1. w/o Diffuser:
    Remove the 10 screws and 4 clips.



    B254518E01
  1. Put protective tape around the bumper cover.

  1. Detach the 4 claws.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose.

  1. Disconnect the 2 fog light connectors and remove the front bumper cover.



6. REMOVE FRONT BUMPER NO. 2 ENERGY ABSORBER


B252775
  1. Remove the front bumper No. 2 energy absorber.



7. REMOVE FRONT BUMPER ENERGY ABSORBER LH


B252776
  1. Remove the front bumper energy absorber.



8. REMOVE FRONT BUMPER ENERGY ABSORBER RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE FRONT BUMPER LOWER ABSORBER


    B252777
  1. Remove the front bumper lower absorber.



10. REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY


B252778
  1. Remove the 2 bolts and front bumper center stay.



11. REMOVE LOW PITCHED HORN ASSEMBLY


B252780
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.



12. REMOVE HIGH PITCHED HORN ASSEMBLY


B252779
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.



13. REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY


B252781
  1. Remove the 2 bolts and front bumper upper reinforcement.



14. REMOVE FRONT BUMPER REINFORCEMENT


B252782
  1. Detach the clamp and remove the cooler thermistor.

  1. Detach the 2 clamps and remove the wire harness.

  1. Remove the 8 bolts and front bumper reinforcement.



15. REMOVE FRONT BUMPER SIDE RETAINER LH


B252774E01
  1. Remove the bolt and clip.

  1. Detach the claw and remove the front bumper side retainer.



16. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure described for the LH side.