Home › BODY ELECTRICAL › HORN › HIGH PITCHED HORN (w/ Hood Moulding)

HIGH PITCHED HORN (w/ Hood Moulding) > INSTALLATION

for Preparation Click here



1. INSTALL HIGH PITCHED HORN ASSEMBLY


B252779
  1. Install the horn with the bolt.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. Connect the horn connector.



2. INSTALL FRONT BUMPER COVER


    B254536
  1. w/ Headlight Cleaner System:
    Connect the headlight cleaner hose.

  1. Connect the 2 fog light connectors.

  1. Attach the 4 claws to install the front bumper cover.



    B254517
  1. w/ Diffuser:
    Install the 4 clips and 8 screws.



    B255284
  1. w/o Diffuser:
    Install the 4 clips and 8 screws.



    B254462
  1. Position the groove on the pin hold clip vertically and insert the clip to install it.

    NOTICE:
    Make sure that the groove on the pin hold clip is positioned vertically.

    HINT:
    Use the same procedure for the RH and LH sides.



3. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH (w/ Diffuser)


B252770
  1. Install the front fender front splash shield with the nut, bolt and screw.



4. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH (w/ Diffuser)

HINT:
Use the same procedure described for the LH side.



5. INSTALL RADIATOR GRILLE PROTECTOR


B254516
  1. Install the 3 radiator grille protectors.



6. INSTALL RADIATOR SUPPORT OPENING COVER


B254515
  1. Install the radiator support opening cover with the 9 clips.