Home › BODY ELECTRICAL › HORN › HIGH PITCHED HORN (w/ Hood Moulding)

HIGH PITCHED HORN (w/ Hood Moulding) > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


B254515
  1. Remove the 9 clips and radiator support opening cover.



2. REMOVE RADIATOR GRILLE PROTECTOR


B254516
  1. Remove the 3 radiator grille protectors.



3. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH (w/ Diffuser)


B252770
  1. Remove the bolt, nut, screw and front fender front splash shield.



4. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (w/ Diffuser)

HINT:
Use the same procedure described for the LH side.



5. REMOVE FRONT BUMPER COVER


    B252771E01
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.



    B254517
  1. w/ Diffuser:
    Remove the 8 screws and 4 clips.



    B255284
  1. w/o Diffuser:
    Remove the 10 screws and 4 clips.



    B254518E01
  1. Put protective tape around the bumper cover.

  1. Detach the 4 claws.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose.

  1. Disconnect the 2 fog light connectors and remove the front bumper cover.



6. REMOVE HIGH PITCHED HORN ASSEMBLY


B252779
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.