CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the secondary oil pressure.
Fully apply the parking brake and chock the 4 wheels.
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Connect the TC and TE1.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest secondary oil pressure reading when the engine speed reaches stall speed and release the accelerator pedal immediately.
Keep your left foot firmly on the brake pedal and move the shift lever to R.
Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest secondary oil pressure reading when the engine speed reaches stall speed and release the accelerator pedal immediately.
| Shift Lever Position | Secondary Oil Pressure |
| D | 3.39 to 4.60 MPa (34.6 to 46.9 kgf/cm2, 492 to 667 psi) |
| R | 2.76 to 3.80 MPa (28.1 to 38.7 kgf/cm2, 400 to 551 psi) |