CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM > INITIALIZATION |
| Replaced Part |
|
| RESET MEMORY/CALIBRATION |
Perform reset memory as follows:
Turn the ignition switch off.
Move the shift lever to P and apply the parking brake.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Reset Memory.
Perform yaw rate sensor assembly*1 or deceleration sensor*2 calibration (deceleration sensor 0 point calibration) as follows:
Turn the ignition switch to ON and wait at least 2 seconds.
Enter the following menus: Powertrain / Engine and ECT / Utility / Deceleration Sensor 0 Point Calibration.
Perform CVT oil pressure calibration as follows:
Turn the ignition switch off and wait at least 30 seconds.
Turn the ignition switch to ON and wait at least 2 seconds.
Start the engine and wait at least 5 seconds.
Enter the following menus: Powertrain / Engine and ECT / Utility / CVT Oil Pressure Calibration.