DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
DTC P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance (Shift Solenoid Valve DSU) |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P0741 |
|
|
| P2757 |
| |
|
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0741 AND P2757) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P0741 and/or P2757 is output | A |
| P0741 and/or P2757 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 3.PERFORM DRIVE TEST |
![]() |
| *1 | Oil seal |
| *a | Example of the damage |
| *b | Damage |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / SPD (NT), Lock Up and Engine Speed.
Check the Data List while driving.
| Result | Proceed to |
| When the lock-up is on, the turbine speed is lower than the engine speed. | A |
| When the lock-up is off, the turbine speed is equal to the engine speed. | |
| When the lock-up is on, the turbine speed is equal to the engine speed. | B |
| When the lock-up is off, the turbine speed is lower than the engine speed. |
|
| ||||
| A | |
| 4.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
Replace the continuously variable transaxle assembly (Click here).
| NEXT | |
| 5.REPLACE TORQUE CONVERTER ASSEMBLY |
| NEXT | |
| 6.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||