Home › TRANSMISSION ยท K111F CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM

DTC    U0129    Lost Communication with Brake System Control Module


DESCRIPTION

The ECM receives signals sent from the skid control ECU via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
U0129
  1. The ignition switch is ON.
  2. There is no communication between the ECM and skid control ECU.
  3. 2.4 seconds
  4. 1 trip detection logic
  1. CAN communication system
  2. Brake actuator assembly (Skid control ECU)
  3. ECM

INSPECTION PROCEDURE

1.CLEAR DTC AND PERFORM ROAD TEST
  1. Clear the DTCs (Click here).

    HINT:
    Write down the currently output DTCs before clearing them.

  1. Start the engine and drive the vehicle at a low speed.


NEXT


2.CHECK DTC OUTPUT (DTC U0129)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs using the tester.
    Result 
    Result
    Proceed to
    U0129 is not output
    A
    U0129 is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)