SFI SYSTEM > Lack of Power or Hesitation |
| 1.CHECK WHETHER DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM BASIC INSPECTION |
Check the air cleaner filter element.
Check if there are any clogs in the intake or exhaust system.
Check the ignition timing .
Check the fuel pressure .
Check the spark .
Measure the cylinder compression pressure .
| Result | Proceed to |
| Everything normal | A |
| Repaired problem area but malfunction reoccurs | A |
| Repaired problem area and malfunction does not reoccur | B |
|
| ||||
| A | |
| 3.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Short FT #1, Long FT #1, AFS Voltage B1 S1 and O2S B1 S2.
Read the value while the vehicle is being driving.
| Result | Proceed to |
| No abnormal values in Data List | A |
| Abnormal values in Data List | B |
|
| ||||
| A | |
| 4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank1).
Read the value.
| Result | Proceed to |
| VVT angle follows VVT target angle | A |
| VVT angle does not follow VVT target angle | B |
|
| ||||
| A | |
| 5.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VALVEMATIC (ENG ON).
Maintain an engine speed of 3000 rpm with the shift lever in P (for CVT), or neutral (for Manual Transaxle) and the vehicle stationary.
Read the value.
| Test Condition | Result |
| High | VALVEMATIC Current Angle: 260°CA MAP: 20 to 35 kPa |
| Low | VALVEMATIC Current Angle: 106°CA MAP: 70 to 100 kPa |
|
| ||||
| OK | ||
| ||