Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Back Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The inner rear view mirror assembly receives a back door condition signal from the back door courtesy light switch.

WIRING DIAGRAM


E173382E06


INSPECTION PROCEDURE

1.INSPECT BACK DOOR COURTESY LIGHT SWITCH
E172204E04
  1. Remove the back door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K18-1 - Body ground
    Not pushed (On)
    Below 1 Ω
    K18-1 - Body ground
    Pushed (Off)
    10 kΩ or higher



NG
REPLACE BACK DOOR COURTESY LIGHT SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - BACK DOOR COURTESY LIGHT SWITCH)
E173383E02
  1. Disconnect the R11 inner rear view mirror assembly connector.

  1. Disconnect the K18 back door courtesy light switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R11-10 (BCTY) - K18-1
    Always
    Below 1 Ω
    R11-10 (BCTY) - Body ground
    Always
    10 kΩ higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)