Home › BODY › EXTERIOR › REAR BUMPER (for Long Body)

REAR BUMPER (for Long Body) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR CENTER BUMPER SUB-ASSEMBLY (w/ License Plate Light)


B208487
  1. Detach the 7 clips and 3 guides, and remove the rear center bumper.



2. REMOVE LICENSE PLATE LIGHT ASSEMBLY (w/ License Plate Light)
  1. Disconnect the connector.



    B132930E02
  1. Using a screwdriver, remove the light as shown in the illustration.



3. REMOVE REFLEX REFLECTOR ASSEMBLY LH


B208484
  1. Remove the screw and reflex reflector.



4. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Outside Moulding)


B208508
  1. Remove the screw.

  1. Detach the 5 clips and remove the side moulding.



6. REMOVE REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY RH (w/ Outside Moulding)

HINT:
Use the same procedure described for the LH side.