Home › TRANSMISSION ยท K111F CVT › SHIFT PADDLE SWITCH

SHIFT PADDLE SWITCH > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE STEERING PAD
  1. Remove the steering pad (Click here).



4. REMOVE STEERING WHEEL ASSEMBLY (for LHD)


    C195901E01
  1. Remove the nut and place matchmarks on the steering wheel and steering column.



    C195902E01
  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.



5. REMOVE STEERING WHEEL ASSEMBLY (for RHD)


    C203467E01
  1. Remove the nut and place matchmarks on the steering wheel and steering column.



    C203468E01
  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.



6. REMOVE STEERING PAD SWITCH ASSEMBLY


C203398
  1. Disconnect the transmission shift switch connector and detach the steering pad switch harness connector from the lower steering boss cover.

  1. w/ Bluetooth:
    Remove the 2 screws, detach the 2 pins and remove the 2 steering pad switches.

  1. w/o Bluetooth:
    Remove the 2 screws, detach the 2 pins and remove the steering pad switch and steering wheel ornament.



7. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY LH AND RH


C204595
  1. Remove the 2 screws.



    C204594
  1. Detach the switch wire from the grooves of the lower steering boss cover and remove the LH and RH transmission shift switches together with the No. 1 switch wire.



    C204596
  1. Cut the 2 cable ties, disconnect the connectors and remove the No. 1 switch wire from the LH and RH transmission switches.