Home › ENGINE ยท 3ZR-FAE › CHARGING › GENERATOR

GENERATOR > INSTALLATION

for Preparation Click here



1. INSTALL GENERATOR ASSEMBLY


    A156000
  1. Install the wire harness clamp bracket with the bolt.

    Torque:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }



    A205694
  1. Temporarily install the generator with the bolt.



    A205693
  1. Temporarily install the adjusting bar with the 2 bolts.



    A169649
  1. Install the wire harness to terminal B with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.

  1. Connect the connector and wire harness clamp.

  1. Install V-ribbed belt .

  1. Adjust V-ribbed belt .

  1. Inspect V-ribbed belt .



    A205804
  1. Tighten the bolt.

    Torque:
    19 N*m{ 189 kgf*cm , 14 ft.*lbf }



2. INSTALL REAR ENGINE UNDER COVER RH


    A196892
  1. Install the under cover with the 3 clips.



3. INSTALL NO. 1 ENGINE UNDER COVER


    A206200
  1. Install the under cover with the 6 screws and 10 clips.



4. INSTALL NO. 2 CYLINDER HEAD COVER


    A209050
  1. Attach the 4 clips to install the cover.

    NOTICE:
    1. Be sure to attach the clips securely.
    2. Do not apply excessive force or do not hit the cover to attach the clips. This may cause the cover to break.



5. INSTALL RADIATOR SUPPORT OPENING COVER
  1. Install the radiator support opening cover with the 9 clips.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL