GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR PULLEY WITH CLUTCH |
![]() |
Hold the center of the generator pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
| *1 | Free |
| *2 | Lock |
| 2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the length of the exposed brushes.
| 3. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the generator rotor for an open circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Slip ring - Slip ring | Approx. 20°C (68°F) | 2.3 to 2.7 Ω |
![]() |
Check the generator rotor for a short to ground.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Slip ring - Rotor | Always | 10 kΩ or higher |
![]() |
Check that the generator rotor bearing is not rough or worn, and that it rotates smoothly.
If the result is not as specified, replace the generator rotor assembly.
![]() |
Using a vernier caliper, measure the diameter of each slip ring.
| 4. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the generator rotor bearing is not rough or worn, and that it rotates smoothly.
If the result is not as specified, replace the generator rotor bearing.