Home › ENGINE ยท 3ZR-FAE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



3. REMOVE REAR ENGINE UNDER COVER RH


    A196892
  1. Remove the 3 clips and under cover.



4. REMOVE RADIATOR SUPPORT OPENING COVER


  1. Remove the 9 clips and radiator support opening cover.


    A226478E01



5. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



6. REMOVE V-RIBBED BELT


    A165469E01
  1. Loosen bolts A and B.

  1. Loosen bolt C and remove the V-ribbed belt.

    NOTICE:
    Do not loosen bolt D.



7. REMOVE GENERATOR ASSEMBLY


    A169649
  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the connector and wire harness clamp.



    A206588
  1. Loosen the 3 bolts.



    A205693
  1. Remove the 2 bolts and adjusting bar.



    A205694
  1. Remove the bolt and generator.



    A156000
  1. Remove the bolt and wire harness clamp bracket.