Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > DISASSEMBLY

for Preparation Click here



1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    B255046
  1. Disconnect the connector.

  1. Remove the 2 screws and the side turn signal light assembly LH.



2. REMOVE OUTER MIRROR RETRACTOR LH


  1. Remove the gasket



      B255053E01
    1. Remove the vinyl tape from the gasket.



    2. B234809E01
    3. Cut the wire harness at the position shown in the illustration.

    4. Remove the gasket.



  1. Remove the base

    1. Remove the wire harness.



    2. B234812
    3. Using a T25 "TORX" socket wrench, remove the 3 screws and base.

      NOTICE:
      Make sure to replace the "TORX" screws with new ones.



  1. Remove the mirror actuator and frame sub-assembly



      B234814
    1. Remove the 3 screws.



    2. B255047
    3. Disengage the claw.



    4. B255048
    5. Slide the guide in the direction indicated by the arrow in the illustration and remove the mirror actuator with frame sub-assembly.



  1. Remove the mirror actuator



      B234817
    1. Remove the 3 screws.



    2. B234758
    3. Disconnect the connector.

      HINT:
      When disconnecting the mirror actuator connectors, use a screw driver wrapped with protective tape.

    4. Disengage the clamp to remove the mirror actuator.