Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REASSEMBLY

for Preparation Click here



1. INSTALL OUTER MIRROR RETRACTOR LH


  1. Install a new wire harness



      B255049
    1. Pass the new wire harness through the outer mirror retractor LH.



    2. B255050
    3. Connect the connector.



  1. Install the mirror actuator



      B234762
    1. Connect the connector.

    2. Engage the new wire harness to the 2 clamps.



    3. B234817
    4. Install the mirror actuator with the 3 screws.



  1. Install the mirror actuator and frame sub-assembly

    1. Pass the wire harnesses through the housing.



    2. B255051
    3. Slide the guide in the direction indicated by the arrow in the illustration.



    4. B255047
    5. Engage the claw.



    6. B234814
    7. Install the actuator with frame sub-assembly with the 3 screws.



  1. Install the base

    1. Pass the wire harness through the base.



    2. B234812
    3. Using a T25 "TORX" socket wrench, install the base with 3 new screws.

      Torque:
      3.8 N*m{ 39 kgf*cm , 34 in.*lbf }

      NOTICE:
      When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.



    4. B255040
    5. Pass the wire harness through the base.



  1. Install the gasket

    1. Pass the wire harness through the gasket and install the gasket.



    2. B255052E01
    3. Align the marking (pink) on the wire harness with the protrusion of the gasket and fit the wire harness under the gasket.



    4. B255053E01
    5. Wind vinyl tape around the wire harness to secure.



  1. Install the connector



      B234769E01
    1. Connect the connector of the shorter wire harness to the adapter.

    2. Route the longer wire harness as shown in the illustration and connect the connector to the adapter.



2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    B255046
  1. Connect the connector.

  1. Install the side turn signal light assembly LH with the 2 screws.