Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM
NM30B0U _56 Audio / Visual / Telematics _009437 PARK ASSIST / MONITORING _0051116 INTUITIVE PARKING ASSIST SYSTEM CO CONTROL F

PARK ASSIST / MONITORING  INTUITIVE PARKING ASSIST SYSTEM  CONTROL  INTUITIVE PARKING ASSIST CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The components have the following functions:

Component Function
No. 1 Ultrasonic Sensor Detects the distance between the vehicle and on obstacle.
No. 1 Clearance Warning Buzzer Sounds to inform the driver according to the distance to the obstacle.
Clearance Warning ECU Assembly
·

Judges the approximate distance between the vehicle and an obstacle based on signals from the No. 1 ultrasonic sensors. Output signals are sent to the telltale light assembly.

·

Sounds the No. 1 clearance warning buzzer.


Telltale Light Assembly
·

Clearance Warning Indicator Light

·

Clearance Sonar Switch


·

The indicator show the location of the obstacle and the approximate distance between the vehicle and the obstacle.

·

The indicator show an indication of a malfunctioning or frozen ultrasonic sensor to inform the driver.

·

Operating this switch allows the operation of intuitive parking assist system to be enabled or disabled.


Combination Meter Assembly Transmits received vehicle speed signals to the clearance warning ECU assembly.
Park/Neutral Position Switch Assembly Sends a shift R position signal to the clearance warning ECU assembly.



OPERATING CONDITION


a.

The operating condition of each sensor differs according to its installed position as shown in the table below:

Installation Position Operating Condition
Rear Corner
·

Ignition switch is ON.

·

Clearance sonar switch is on.

·

Shift lever is in R.


Rear Center



SYSTEM CONTROL


a.

No. 1 Clearance Warning Buzzer

i.

The on and off times of the No. 1 clearance warning buzzer vary as shown in the table below, depending on the distance between the obstacle and the ultrasonic sensor:

Ultrasonic Sensor Obstacle Distance [mm (in.)] Off Time (ms) On Time (ms)
Center Corner
Detection Level 1st Approx. 600 (23.6) to 1500 (59.1) - 650 +/- 65 150 +/- 15
2nd Approx. 450 (17.7) to 600 (23.6) Approx. 400 (15.7) to 500 (19.7) 150 +/- 15 150 +/- 15
3rd Approx. 350 (13.8) to 450 (17.7) Approx. 300 (11.8) to 400 (15.7) 75 +/- 7.5 75 +/- 7.5
4th Approx. 350 (13.8) or less Approx. 300 (11.8) or less 0 Continuous



b.

Detection Area

i.

The detection areas of the No. 1 ultrasonic sensors are as shown in the following illustration.


ii.

These detection areas are applicable when positioning a 60 mm (2.36 in.) diameter pole parallel or perpendicular to the ground. The ranges vary depending on the measuring method and type of obstacle.

Y128806
5.115,1.198 5.271,1.396 0.156,0.198 10 A 4.854,1.219 5.01,1.417 0.156,0.198 10 B 4.979,3.521 5.135,3.719 0.156,0.198 10 A 4.771,3 4.927,3.198 0.156,0.198 10 B 4.771,4.052 4.927,4.25 0.156,0.198 10 B

No. 1 Ultrasonic Sensor Distance Area
Ultrasonic Sensor Obstacle Distance [mm (in.)]
Center Corner
A B
Detection Level 1st Approx. 600 (23.6) to 1500 (59.1) -
2nd Approx. 450 (17.7) to 600 (23.6) Approx. 400 (15.7) to 500 (19.7)
3rd Approx. 350 (13.8) to 450 (17.7) Approx. 300 (11.8) to 400 (15.7)
4th Approx. 350 (13.8) or less Approx. 300 (11.8) or less



c.

Clearance Warning Indicator Light

i.

The driver is informed that there is an obstacle nearby by the flashing of the clearance warning indicator assembly located on the instrument panel. Also, the No. 1 clearance warning buzzer sounds simultaneously.

Y129991
1.844,0.792 2.146,0.792 true 2.729,0.792 3.031,0.792 true 2.729,1.052 2.458,0.948 true 2.365,1.219 2.677,1.417 0.313,0.198 10 false *1 1.688,0.719 2,0.917 0.313,0.198 10 false *a 2.771,0.969 3.083,1.167 0.313,0.198 10 false *b 3.094,0.719 3.406,0.917 0.313,0.198 10 false *c
*1 Clearance Warning Indicator Light - -
*a Rear Corner LH *b Rear Center
*c Rear Corner RH - -





DIAGNOSIS


a.

If a system malfunction is detected, the clearance warning ECU assembly stores Diagnostic Trouble Codes (DTCs) in its memory. For details, refer to the Repair Manual.