Home › Power Source / Network › 2AR-FE BATTERY / CHARGING › CHARGING SYSTEM
NM30B0U _57 Power Source / Network _009871 2AR-FE BATTERY / CHARGING _0054282 CHARGING SYSTEM CO CONTROL F

2AR-FE BATTERY / CHARGING  CHARGING SYSTEM  CONTROL  CHARGING CONTROL  


SYSTEM CONTROL


a.

When whole status of driving, this system regulates the generated voltage in order to place the amperage estimation value close to the target value. This reduces the load on the engine as a result of the electric generation of the generator, thus contributing to the fuel economy of the engine.


b.

This control consists of a generator control ECU assembly with a built-in battery current sensor and battery temperature sensor, generator, various sensors, switches and ECM.


c.

The ECM detects the driving condition based on signals from various sensors and switches generator control ECU assembly detects the charging condition based on signals from the generator assembly, battery currentsensor and battery temperatur sensor. The ECM determines the vehicle driving conditions, and based on this information, the generator control ECU assembly sends a voltage request signal to the generator assembly.


d.

The generator control ECU assembly stops the charging control and the generator switches to normal power generation mode under the following conditions:

i.

Low battery capacity


ii.

Low battery temperature


iii.

Battery current sensor or battery temperature sensor malfunction


iv.

Engine started


v.

Communication failure (local communication between generator control ECU assembly and ECM)


vi.

Generator assembly malfunction


vii.

Battery charged for approximately 2.5 to 4 hours


viii.

Accumulated driving time becomes approximetely 20 hours