Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT SYSTEM
NM30B0U _52 Drivetrain _008840 DRIVE SHAFT / PROPELLER SHAFT _0060888 PROPELLER SHAFT SYSTEM GE GENERAL F

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

Rear Propeller Shaft (AWD Models)

i.

A 3-joint, 2-shaft type propeller shaft is used.


ii.

A tripod type Constant-Velocity Joint (CVJ), which is more compact and lightweight than the conventional cross-groove type CVJ, is used for the center CVJ. Furthermore, a compact and lightweight shell-cap type joint is used at each end.

X111819
1.583,0.979 1.583,0.5 true 3.229,0.781 3.229,0.5 true 4.01,0.865 4.01,0.5 true 5.656,0.979 5.656,0.5 true 1.51,0.313 1.823,0.469 0.313,0.156 10 *1 3.938,0.313 4.25,0.469 0.313,0.156 10 *2 3.167,0.313 3.406,0.573 0.24,0.26 10 *3 5.583,0.313 5.896,0.469 0.313,0.156 10 *1
*1 Shell-cap Type Joint *2 Tripod Type CVJ
*3 Center Bearing - -
V100135

Transfer Side
V100136

Rear Differential Side