Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM30B0U _54 Brake _008846 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0060895 BRAKE CONTROL SYSTEM DE DETAILS F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  DETAILS  STEERING ANGLE SENSOR  


CONSTRUCTION


a.

The steering angle sensor detects the steering direction and angle, and sends this signal to the skid control ECU.


b.

The steering angle sensor contains 2 sets of magnetic reluctance elements that detect the rotational movement of a magnet that is built into the detection gear. Thus, the sensor detects the changes that occur in the magnetic reluctance elements along with the rotational movement of the detection gear, in order to detect the rotational movement of the steering wheel.

X111930
2.396,2.083 2.938,1.865 true 3.458,2.094 4.219,2.281 4.219,2.281 3.771,1.792 true 2.219,2.021 2.531,2.177 0.313,0.156 10 *1 4.271,2.219 4.583,2.375 0.313,0.156 10 *2
*1 Steering Sensor *2 Detection Gear


NOTICE:

Do not remove the steering angle sensor from the spiral cable. If there is a malfunction in the steering angle sensor, replace the spiral cable with steering angle sensor.


HINT:

When removing and reinstalling the spiral cable with steering angle sensor sub-assembly, it is necessary to use a special procedure to prevent the center position of the steering sensor from becoming misaligned. For details, refer to the Repair Manual.