INITIALIZATION
If the ECM is replaced, register the ECU communication ID for Immobiliser System (w/o smart key system).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle with motor body components.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Perform Registration (VIN registration) when replacing the ECM.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION
Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
WHEN USING TECHSTREAM
Observe the following items for safety reasons:
Before using the Techstream, read the instruction manual.
Prevent the Techstream cable from being caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
When driving the vehicle for testing purposes using the Techstream, 2 persons are required. One drives the vehicle, and the other operates the Techstream.
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs depending on the specifications of the vehicle.
The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition switch off | LOCK | Off (Lock) |
| Ignition switch ACC | ACC | On (ACC) |
| Ignition switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After the ignition switch is turned off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION