Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049656 CAMSHAFT OIL CONTROL VALVE G

2AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the Techstream to the DLC3.


b.

Start the engine and turn the Techstream on.


c.

Warm up the engine.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank1) or Control the VVT Exhaust Linear (Bank1).

Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32
Powertrain > Engine and ECT > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank1)
50004 234 87

e.

Check the engine speed while operating the Oil Control Valve (OCV) using the Techstream.

Standard Condition:
Tester Operation Specified Condition
OCV is OFF Normal engine speed
OCV is ON Soon after OCV switched from OFF to ON, engine idles roughly or stalls


If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.