Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › THROTTLE BODY
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049657 THROTTLE BODY A

2AR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

a.
A293380

Lift the rear of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the pin and remove the No. 1 engine cover sub-assembly.


Hide 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 4.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

a.
A293382

Slide the clamp and disconnect the No. 1 water by-pass hose from the throttle with motor body assembly.


b.

Slide the clamp and disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.


c.

Remove the bolt and disconnect the fuel hose bracket.

NOTICE:

If the fuel hose is detached from the clamp shown in the illustration, the clamp cannot be reused.



d.

Disconnect the throttle with motor body assembly connector.


e.
A293383

Remove the 4 bolts and throttle with motor body assembly.


f.
A238209

Remove the gasket from the intake manifold.