Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ECM
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049658 ECM A

2AR-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket with the 2 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket with the 2 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 3.INSTALL ECM

a.

Install the ECM with the 3 bolts.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


b.
A293347

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
·

When connecting a connector, make sure that dirt, water and other foreign matter is not stuck between the connector and ECM.

·

Make sure that the 2 levers are securely lowered.




Hide 4.INSTALL AIR CLEANER CASE

a.

Install the air cleaner case with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Attach the harness clamp.


Hide 5.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

a.

Install the air cleaner filter element to the air cleaner case.


b.
A293390
0.104,2.729 0.271,2.906 0.167,0.177 10 *a 0.969,2.094 1.135,2.271 0.167,0.177 10 *b
*a RH Side
*b Rear


Align the protrusion on the end of the air cleaner cap sub-assembly with the edge of the throttle with motor body assembly and connect the hose. Then, release the lock of the air cleaner cap sub-assembly clamp to secure the clamp.


c.
A293391
0.76,2.719 1.396,2.344 1.396,2.344 1.677,2.344 true 1.708,2.26 1.885,2.427 0.177,0.167 10 *1
*1 Hinge


Insert the hinge part of the air cleaner cap sub-assembly into the air cleaner case, and then attach the 2 hook clamps.


d.

Connect the No. 2 PCV hose to the cylinder head cover.


e.

Connect the fuel vapor feed hose and No. 2 fuel vapor feed hose to the purge VSV, and slide the 2 clamps to secure it.


f.

Attach the 2 wire harness clamps.


g.

Connect the purge VSV connector.


h.

Connect the mass air flow meter sub-assembly connector.


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 7.PERFORM REGISTRATION

·

When replacing the ECM, input the Vehicle Identification Number (VIN) into the new ECM.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION


Hide 8.RESET MEMORY (for Automatic Transaxle)

·

When replacing the ECM, perform the Reset Memory procedure (A/T initialization).

Click hereDrivetrain>U760F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION