Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049659 ACCELERATOR PEDAL A

2AR-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.


a.
A299654

Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 2 bolts and accelerator pedal sensor assembly.

NOTICE:
·

Avoid physical shocks to the accelerator pedal sensor assembly.


·

Do not disassemble the accelerator pedal sensor assembly.