Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049659 ACCELERATOR PEDAL G

2AR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Powertrain > Engine and ECT > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

e.

Read the value displayed on the Techstream.

Standard Voltage:

Accel Sensor Out No. 1

Condition Specified Condition
Accelerator pedal is released 0.5 to 1.1 V
Accelerator pedal is depressed 2.6 to 4.5 V


Standard Voltage:

Accel Sensor Out No. 2

Condition Specified Condition
Accelerator pedal is released 1.2 to 2.0 V
Accelerator pedal is depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.