Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049660 MASS AIR FLOW METER G

2AR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A195393
1.708,2.802 1.615,2.885 1.615,2.885 1.625,3.708 true 1.542,3.74 1.729,3.917 0.188,0.177 10 *1
*1 Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly as shown in the illustration.

OK:

There is no foreign matter.



b.

Check the intake air temperature sensor (built into the mass air flow meter sub-assembly).

i.
A196153
1.917,1.406 2.052,1.865 2.052,1.865 2.135,1.865 false 2.146,1.313 2.469,1.052 2.469,1.052 2.594,1.052 false 2.156,1.781 2.365,1.958 0.208,0.177 10 E2 2.667,0.958 2.979,1.115 0.313,0.156 10 THA 0.063,0.063 0.417,0.438 0.354,0.375 10 *a
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the mass air flow meter sub-assembly.