Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049661 CAMSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.


b.

Clean the bolt and bolt hole.


c.

Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.



d.

Install the camshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




e.

Connect the camshaft position sensor connector.


Hide 2.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.


b.

Clean the bolt and bolt hole.


c.

Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.



d.

Install the camshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




e.

Connect the camshaft position sensor connector.


Hide 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY