Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049662 CRANKSHAFT POSITION SENSOR A

2AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Clean the bolt and bolt hole.


c.

Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.



d.

Install the crankshaft position sensor with the bolt.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:
·

When reusing the crankshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the crankshaft position sensor.




e.

Connect the crankshaft position sensor connector.


Hide 3.INSTALL REAR ENGINE UNDER COVER RH