Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM30B0U _51 Engine / Hybrid System _008971 2AR-FE ENGINE CONTROL _0049664 ENGINE COOLANT TEMPERATURE SENSOR G

2AR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

A196021
5.948,1.104 6.188,0.698 6.188,0.698 6.313,0.698 false 4.823,0.021 5.042,0.26 0.219,0.24 10 *1 6.375,0.604 6.583,0.823 0.208,0.219 10 *3 5.063,0.125 5.385,0.333 0.323,0.208 8 30 5.063,0.26 5.385,0.469 0.323,0.208 8 20 5.063,0.479 5.385,0.688 0.323,0.208 8 10 5.063,0.719 5.385,0.927 0.323,0.208 8 5 5.063,0.885 5.385,1.094 0.323,0.208 8 3 5.063,1.021 5.385,1.229 0.323,0.208 8 2 5.063,1.24 5.385,1.448 0.323,0.208 8 1 5.042,1.781 5.365,1.99 0.323,0.208 8 0.2 5.042,1.646 5.365,1.854 0.323,0.208 8 0.3 5.042,1.479 5.365,1.688 0.323,0.208 8 0.5 5.042,2.01 5.365,2.219 0.323,0.208 8 0.1 5.563,2.292 5.76,2.458 0.198,0.167 8 0 5.76,2.292 5.99,2.458 0.229,0.167 8 20 6.01,2.292 6.292,2.615 0.281,0.323 8 40 6.26,2.292 6.5,2.479 0.24,0.188 8 60 6.51,2.292 6.938,2.615 0.427,0.323 8 80 6.792,2.292 7.146,2.615 0.354,0.323 8 100 5.24,2.292 5.448,2.479 0.208,0.188 8 -20 4.948,2.323 5.219,2.521 0.271,0.198 10 *2 1.177,0.833 1.406,1.094 0.229,0.26 10 *a 4.813,0.292 5.042,0.479 0.229,0.188 10 kΩ 5.875,2.583 6.344,2.771 0.469,0.188 10 °C (°F) 5.25,2.438 5.531,2.615 0.281,0.177 8 (-4) 5.5,2.427 5.781,2.604 0.281,0.177 8 (32) 5.719,2.438 6,2.615 0.281,0.177 8 (68) 5.948,2.427 6.365,2.604 0.417,0.177 8 (104) 6.219,2.427 6.604,2.625 0.385,0.198 8 (140) 6.49,2.427 6.854,2.615 0.365,0.188 8 (176) 6.781,2.427 7.135,2.625 0.354,0.198 8 (212)
*1 Resistance *2 Temperature
*3 Acceptable Range - -
*a Component without harness connected
(Engine Coolant Temperature Sensor)
- -


a.

Partially immerse the sensor in water and warm up the water.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.


If the result is not as specified, replace the engine coolant temperature sensor.