Home › Engine / Hybrid System › 2AR-FE COOLING › RADIATOR
RM30B0U _51 Engine / Hybrid System _009233 2AR-FE COOLING _0050393 RADIATOR G

2AR-FE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT RESERVOIR CAP

a.
A215769
0.906,1.521 1.208,1.521 false 2.01,1.281 2.313,1.281 true 0.74,1.448 1.052,1.604 0.313,0.156 10 *1 2.344,1.198 2.656,1.354 0.313,0.156 10 *2
*1 O-Ring
*2 Rubber Packing


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.


ii.

Check that the O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.


iv.
A110393
0.385,1.156 0.615,0.125 0.615,0.125 0.688,0.125 false 1.469,1.042 1.573,0.5 1.573,0.5 1.656,0.5 false 0.719,0.052 1.031,0.208 0.313,0.156 10 *1 1.677,0.417 1.99,0.573 0.313,0.156 10 *2 0.583,1.698 0.896,1.854 0.313,0.156 10 *a
*1 Reservoir Cap
*2 Radiator Cap Tester
*a 30° or more


When using the radiator cap tester, tilt it more than 30° degrees.


v.

Pump the radiator cap tester several times and check the maximum pressure*.

Pump speed:

1 pump per second


*: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Standard Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum standard value
(for used cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the reservoir cap.



Hide 2.INSPECT FINS FOR BLOCKAGE

a.

If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.

NOTICE:
·

To avoid damaging the fins, the injection direction should be at right angles to the core surface.

·

If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so maintain the following injection distances.

Standard Injection Distance:
Injection Pressure Specified Condition
2942 to 4903 kPa (30.0 to 50.0 kgf/cm2, 427 to 711 psi) 300 mm (11.8 in.)
4903 to 7845 kPa (50.0 to 80.0 kgf/cm2, 711 to 1138 psi) 500 mm (19.7 in.)


·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Do not expose electronic components to water.




b.

Dry the fins with compressed air.