Home › Engine / Hybrid System › 2AR-FE LUBRICATION › OIL PRESSURE SWITCH
RM30B0U _51 Engine / Hybrid System _009177 2AR-FE LUBRICATION _0050592 OIL PRESSURE SWITCH A

2AR-FE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.


NOTICE:

Do not let adhesive adhere to the oil hole.



b.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



c.

Connect the engine oil pressure switch connector.