CHECK DTC
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Charging Control / Trouble Codes.
Check the DTCs, and then write them down.
Check the details of the DTCs.
Click herePower Source / Network>2AR-FE BATTERY / CHARGING>CHARGING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
CLEAR DTC
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Charging Control / Trouble Codes.
Clear the DTCs.